View All Jobs at ideaForge
Refer a Friend
Job Description
Should be sound with basics, fundamentals and essentials of Electronics and Power Electronics
Should be good at designing basic Electronic circuits
Should be experienced at designing and hands-on development of Embedded System circuits and firmware using Microcontrollers eg. STM32
Should have a hands on with GPIO programming, ADCs, Timers, Counters, UART, SPI, I2C, Ethernet, USB, etc.
Should be experienced with various communication protocols such as UART, SPI, I2C, CAN, USB, Ethernet, etc.
Should have an experience with firmware for CAN protocol
Should preferably have development experience with RF Transceivers, Bluetooth, LoRa, GSM, etc.
Should have an experience designing Buck / Boost Regulator based DC-DC power supplies
Should have adequate experience at reading and utilizing datasheets for the selection of components as per the functional, electrical and environmental requirements
Should be able to read, interpret, review and modify wiring diagrams, circuit diagrams, schematic diagrams and PCB layouts
Should be able to conduct fault findings on various kinds of digital and analog circuits
Should be good at documentation relating to circuit designs and calculations as well as test and validation procedures and results
Should have a clear understanding of layout design practices in terms of EMI/EMC compliance
Should have an hands-on experience with at least one schematic design software eg. Altium
Should have an hands-on experience with at least one PCB design software eg. Altium, Allegro, Eagle, etc.
Should have an expertise in hand soldering of Through-Hole and Surface Mount Components ( SMDs )
Should be strong in C and Embedded C programming
Should have preferably worked on Linux or similar platform
Should be proficient at the testing and debugging of self-written as well as existing firmware codes
Should have strong documentation management and writing skills
Should be aware of the standard requirements of ISO, Aeronautical Standard, etc.
Skills